![]() Wait AT LEAST 5 minutes until the WLAN light turn on, then unplug power on router and wait 30 seconds. best of all the D-series are pretty much unbrickable as the emergency room bootloader is in rom (or something similar) not flash. Go to the Admin->Firmware Upgrade page and flash the downloaded file. Router: TP-Link TL-WR1043ND Firmware: DD-WRT v24-sp2 Kernel: Linux 3.5. At this point reconfigure your PC to use DHCP and then navigate to 192.168.1.1 to access openwrt. I tried doing a 30-30-30 power reset and it didnt do anything. When the flashing is done the router will reboot and the lights will flash green. If you want any special firewall settings, you should configure these on the host router. ![]() At this point you can provide the factory.bin and voila flash away. Click Security/Firewall and click to Disable the SPI Firewall. This takes you to the "emergency room - flash loader)" website. In order to boost the signal strength, position the antenna of the CDD in a parallel. On your PC (macs are similar though), set your IP Address to 192.168.0.10, subnet 255.255.255.0įrom a browser (i used chrome and it worked fine, but I hear IE might be better), navigate to 192.168.0.1 How to install DD-WRT firmware on Asus RT-AC66U router, step by step instructions going from the stock Asus to DD-WRT and then finally flashing KONG build. Go to your DLink Router, take the power plug out, and put & hold a pin/paperclip into the reset button.Īnd the front light should start flashing orange in a couple of seconds.Īt this point the router is in failsafe, emergency mode When you flash in the future you can choose the upgrade.bin I got this working, what you need to do is download the 12.09 (final?) AA build from … ps/rt305x/ or you could go for the bleeding edge atĬhoose the "factory.bin" version for your first flash (e.g, openwrt-ramips-rt305x-dir-615-d-squashfs-factory.bin version )
0 Comments
Leave a Reply. |